Michele-M-Media/HYPERHEN

选用指南

AI 根据 README 整理 · 2026/10/21 08:21:31

使用方式

通过外部加载器发送 HyperHEN.elf 来加载，之后在 PS5 设置中进入 HyperHEN Toolbox 进行配置和使用。

查看 README 依据

7.40, 7.60, 7.61, plus the experimental 13.20 path. Other firmware revisions fail closed. <br> # Run ### Requirements 1. A jailbroken PS5 2. An external [PS5 `elfldr`](https://github.com/ps5-payload-dev/elfldr) listening on port **9021** for the first hop ### Load HyperHEN 1. Run the kernel exploit and start the external `elfldr` service. 2. Send `HyperHEN.elf` through the loader your exploit host provides.

3. HyperHEN selects the exact internal firmware engine automatically. On FW 13.00, 13.20, or 13.60, follow the HyperHEN Hypervisor notification: enter Rest Mode once and resume. On the listed exact 11.60/12.xx profiles, wait for the compatibility-mode notification and the HyperCore runtime check. 4. Open PS5 Settings and enter the HyperHEN Toolbox where the selected route provides it. FW 13.40 and 13.42 intentionally run utility-only and do not inject the Toolbox. Startup is sequential. After the first hop, HyperHEN uses its own

部署要求

需要一台已越狱的 PS5，以及一个在 9021 端口监听的外部 elfldr 作为第一跳。

查看 README 依据

7.40, 7.60, 7.61, plus the experimental 13.20 path. Other firmware revisions fail closed. <br> # Run ### Requirements 1. A jailbroken PS5 2. An external [PS5 `elfldr`](https://github.com/ps5-payload-dev/elfldr) listening on port **9021** for the first hop ### Load HyperHEN 1. Run the kernel exploit and start the external `elfldr` service. 2. Send `HyperHEN.elf` through the loader your exploit host provides.

已知限制

HyperHEN 不包含内核漏洞，第一跳仍需要外部 elfldr。13.40 和 13.42 固件仅运行工具/用户态层，不注入 Toolbox。

查看 README 依据

- **Resilient runtime** — the critical daemon and utility daemon run apart; the main daemon can restart the utility - **Shared configuration** — the Toolbox and daemons use one versioned `config.ini` HyperHEN does not include a kernel exploit. The first hop still needs an external `elfldr` on **9021**. After that, HyperHEN starts its own private loader on **9020** for later ELF and user-payload launches. ### HyperLinux clean-boot mode Open **Advanced Debug → HyperLinux Boot** to arm the embedded Linux loader. Because the upstream Linux boot path is incompatible with kstuff already being

3. HyperHEN selects the exact internal firmware engine automatically. On FW 13.00, 13.20, or 13.60, follow the HyperHEN Hypervisor notification: enter Rest Mode once and resume. On the listed exact 11.60/12.xx profiles, wait for the compatibility-mode notification and the HyperCore runtime check. 4. Open PS5 Settings and enter the HyperHEN Toolbox where the selected route provides it. FW 13.40 and 13.42 intentionally run utility-only and do not inject the Toolbox. Startup is sequential. After the first hop, HyperHEN uses its own